GBtiger is a really nifty heads-up display.
It’s able to project a 5.5-inch virtual image directly on to the windshield, this lets the drivers see the screen and information on their windshield without their eyes ever leaving the road so it greatly increases safety while driving.
This device allows you to constantly monitor over the speed with an alarm if you do! Adapt this device with your cars OBD II (Bus Automatic Diagnostic System) interface socket, which is normally found under the car steering wheel.
Install the non-slip pad onto the instrument panel, then place HUD onto the non-slip pad, now you have the ability to adjust the angle.
The reflective film must be attached to the forward position of HUD and then applied to the front of the windshield.
This will ensure that the information, can be projected onto the reflective film
This HUD is not compatible with European or American cars manufactured before 2003!
Any Asian cars manufactured before 2007 will also not be compatible with this unit. As a safety measure before ordering make sure whether your car has the OBD2 interface.
What it can Do
So What Exactly does this device display?
Well for starters speed, fuel consumption, average fuel consumption, car voltage use. Over speed alarm, water temperature alarm, Gear shift reminder, fatigue driving reminder, fault code display.
An Array of Data Measurements, which range from clock display, engine temperature, fuel consumption, constant live data readouts. The HUD also reads and can clear trouble codes, RPM, throttle position and last but not least Vehicle speed.
Brand Name: GBtiger
Wire or Wireless: OBDII Interface
Rated Power: none
Size Name: 13.00 x 7.50 x 1.30 cm / 5.12 x 2.95 x 0.51 inches
Output Frequency: none
Screen Size: 5.5 inch
Car Make: With On-Board Diagnostic OBDII interface
Environment: about 40c plus 80c atmospheric pressure 86-106kpa
Alarm sound level: more than 30db
Working voltage: DC9 to16V
Working current: 40mA
Sleeping current: 15mA
Speed range: 0 to 400KM
Cable length: 1.5M